Rubber gasket that fits between the backshell and the wing on 2 adjuster type headlamps. This gasket is 32mm wide. A narrower version is available should one be required. Fits with both plastic and steel backshells, 54521487,...
Made of rubber, it fits between the backshell and the wing on 2 adjuster type headlamps, 54520919, 512222. This is the very narrow gasket - 20mm, for the less narrow version refer to 54521488 and for the wide one refer to 54521487
Plastic Backshell Assembly for 7 in headlamps, Made by Wipac, this backshell comes complete with the lamp unit retaining rim (chrome on steel) and can be used with outer rims that are retained by either a screw or a spring clip. (Spring...
Special steel Backshell for 7 in headlamps on Jaguar E Type Series I. The special feature of this backshell is the flattened or truncated section at the rear. Use in conjunction with the standard 2-Adjuster retaining rim and seating...
Chromed retaining rim for 2 adjuster type headlamps 54521913. Alternative to 010.376 which is satinless steel. If you also want the inner seating dish refer to 54058414
Chromed retaining rim and inner seating dish set for 2 adjuster headlamps, 54058414. This is the part of the 2-Adjuster headlamp in which the light unit is fitted
Set of two trimmer screws and inserts plus the spring that goes between the inner seating dish and the backshell. This kit is suitable for steel backshells 60600427, BHM7058
Complete with the special truncated steel backshell required to fit the Jaguar E Type Series I. E marked Halogen light unit with main and dip 60/55 watts, and with wiring harness. Dips to the left hand side of the road. The backshell is...
Made of rubber, this cover fits over the halogen bulbs to keep out dust. The cover pushes on before the plug on the wiring harness, which acts to retain the rubber cover. Fits both halogen H4 and UEC type light units
Made of rubber, it fits between the backshell and the wing on 2 adjuster type headlamps with plastic backshells. This is the narrow gasket - 24mm, for a wider gasket refer to 010.606 - 28.5mm Lucas 554279
Made of rubber, it fits between the backshell and the wing on 2 adjuster type headlamps with plastic backshells. This is the wide gasket - 28.5mm, for a narrower gasket refer to 010.605 - 24mm, 7H8338
Chromed round headed screw used to retain the finishing rim on 7 inch headlamps. Fits both plastic and steel backshells
For Side Mounting. LIMITED NUMBER AVAILABLE
Reproduction of the Lucas 7' Headlamp SS700P, complete with light unit, panel, switch and ammeter. Black enamel shell with chrome rim. As fitted to many British motorcycles
Stainless steel Headlamp Visor to suit 7 in diameter headlamp. No drilling, fits under rim. Sold singly, for a pair refer to 090.321
A quality reproduction of the Lucas 7 in Spotlamp SLR700, Chrome back and curved glass. For a spare bulb (double contact) refer to LLB326
Budget priced Freestanding Headlamp Shell, 7 in diameter, chrome finish. Used as original equipment on various Lotus 7 type cars. Supplied with rim and push on connector but without the light unit to enable you to make your own choice of...
Stainless steel retaining rim for 2 adjuster type headlamps. The part of the rim that shows is polished. Alternative to 54521913 which is chromed