108 mm diameter, base mounted by 10 mm diameter bolt. Depth front to rear 130 mm. Fitted with 12 volt Halogen bulb 60/55 watts and 'E' marked. Also has a sidelight
Original Lucas motorcycle Headlamp, complete with light unitt and on/off switch. Painted WD green
Main and dip beams with sidelight, metal reflector, plastic backshell, gasket and wiring harness. 'E' Marked. No Rim. Fitted with 12 volt Halogen bulb 60/65 watts and 5 watt sidelight bulb. Dips to the left hand side of the road. (Comes...
This chromed retaining rim is a Lucas part
For sidelight/pilot bulb on BPF Headlamps.Uses LLB989 or LLB951
5' is nominal size of lens. Dimension over side mounting points is 147 mm. Depth front to rear 100 mm. 12 volt 35/35 watts. There are two holes at the rear, for suitable Grommets refer to 080.085. For a spare Bulb refer to LLB3604
7 inch steel headlamp backshell only. All the necessary components to build your headlamps up are available separately.
Budget priced Freestanding Headlamp shell, 7 in diameter, black shell. Used as original equipment on various Lotus 7 type cars. Supplied with chromed rim and push on connector but without the light unit to enable you to make your own...
Main and dip beams without sidelight. This headlamp does not have a full backshell, it just has a plastic mounting rim. The light unit/rear of bulb protrude through it and are, therefore, not protected as they are with a full domed...
Main and dip beams with sidelight, plastic reflector, gasket and wiring harness. 'E' Marked. No rim. Fitted with 12 volt Halogen bulb 60/65 watts and 5 watt sidelight bulb. Dips to the left hand side of the road
Plastic Backshell Assembly for 7 in headlamps, Made by Wipac, this backshell comes complete with the lamp unit retaining rim (chrome on steel) and can be used with outer rims that are retained by either a screw or a spring clip. (Spring...
Special steel Backshell for 7 in headlamps on Jaguar E Type Series I. The special feature of this backshell is the flattened or truncated section at the rear. Use in conjunction with the standard 2-Adjuster retaining rim and seating...
Rubber gasket that fits between the backshell and the wing on 2 adjuster type headlamps. This gasket is 28mm wide. A wider version is avaialble should one be required. Fits with both plastic and steel backshells,
Rubber gasket that fits between the backshell and the wing on 2 adjuster type headlamps. This gasket is 32mm wide. A narrower version is avaialble should one be required. Fits with both plastic and steel backshells,
Chromed retaining rim for 2 adjuster type headlamps. Alternative to 010.376 which is satinless steel. If you also want the inner seating dish refer to 54058414
Chromed retaining rim and inner seating dish set for 2 adjuster headlamps. This is the part of the 2-Adjuster headlamp in which the light unit is fitted
Set of two trimmer screws and inserts plus the spring that goes between the inner seating dish and the backshell. This kit is suitable for steel backshells