Lucas 5 3/4" headlamp retaining rim 54524588, 37H7024
For sidelight/pilot bulb on BPF Headlamps.Uses LLB989 or LLB951
Sealed beam head light unit 5 3/4". 60/37.5 watt 12 volts. This unit does not have a side light window. As Lucas SB5731 but without the pilot window. GLU135
Made of rubber, it fits under the headlamp rim to keep out dust. Fits most 7' headlamps 552906, 3H2962
Rubber gasket that fits between the backshell and the wing on 2 adjuster type headlamps. This gasket is 28mm wide. A wider version is avaialble should one be required. Fits with both plastic and steel backshells, 54521488, 13H565
Rubber gasket that fits between the backshell and the wing on 2 adjuster type headlamps. This gasket is 32mm wide. A narrower version is available should one be required. Fits with both plastic and steel backshells, 54521487,...
Plastic Backshell Assembly for 7 in headlamps, Made by Wipac, this backshell comes complete with the lamp unit retaining rim (chrome on steel) and can be used with outer rims that are retained by either a screw or a spring clip. (Spring...
Special steel Backshell for 7 in headlamps on Jaguar E Type Series I. The special feature of this backshell is the flattened or truncated section at the rear. Use in conjunction with the standard 2-Adjuster retaining rim and seating...
Chromed retaining rim for 2 adjuster type headlamps 54521913. Alternative to 010.376 which is satinless steel. If you also want the inner seating dish refer to 54058414
Chromed retaining rim and inner seating dish set for 2 adjuster headlamps, 54058414. This is the part of the 2-Adjuster headlamp in which the light unit is fitted
Set of two trimmer screws and inserts plus the spring that goes between the inner seating dish and the backshell. This kit is suitable for steel backshells 60600427, BHM7058
Made of rubber, this cover fits over the halogen bulbs to keep out dust. The cover pushes on before the plug on the wiring harness, which acts to retain the rubber cover. Fits both halogen H4 and UEC type light units
Made of rubber, it fits between the backshell and the wing on 2 adjuster type headlamps with plastic backshells. This is the narrow gasket - 24mm, for a wider gasket refer to 010.606 - 28.5mm Lucas 554279
Made of rubber, it fits between the backshell and the wing on 2 adjuster type headlamps with plastic backshells. This is the wide gasket - 28.5mm, for a narrower gasket refer to 010.605 - 24mm, 7H8338
Chromed round headed screw used to retain the finishing rim on 7 inch headlamps. Fits both plastic and steel backshells
Stainless steel retaining rim for 2 adjuster type headlamps. The part of the rim that shows is polished. Alternative to 54521913 which is chromed
7 inch steel headlamp backshell only, 54522342. All the necessary components to build your headlamps up are available separately.
Made of rubber, it fits between the backshell and the wing, This is the type for use with 3 adjuster type headlamps. 29mm wide. 554280