'Lucas Screenjet' Washer Bottle Sticker 50 mm x 70 mm
'Trico Solvent' washer bottle sticker. Size 44mm x 100mm
Trico Windscreen Washer sticker
239 mm x 35 mm. Fits small Tudor Washer Bottle
Classic Stainless steel wiper arm with 5mm bayonet fitting for the blade. Fits Lucas 14.8mm splined shafts, 180mm long. As fitted to Citroen 2CV. This arm can also be fitted to 1/4 in plain shafts by using the special plain shaft to...
If you have 1/4 in (approx 6mm) diameter plain shafts, this Adaptor clamps to the shaft and enables you to use spline type wiper arms with the crosshead screw fitting. Use only with a combination of our adjustable spline fitting wiper...
A comprehensive stand-alone kit to fit screen washers to your vehicle. Comprises flexible bag approx 210 mm wide x 290 mm tall, 12 volt electric pump, washer tubing, 2x washer jets and associated pipe connectors, mounting bracket to hang...
A comprehensive stand-alone kit to fit screen washers to your vehicle. Comprises plastic bottle of approximately 1.2 litres capacity with 12 volt electric pump fitted to the side, washer tubing, 2x washer jets and associated pipe...
Comprises plastic connector block and suitable terminals to enable you to make up a harness plug to fit the socket on Lucas 2 speed wiper motors
Useful as a spare part for the connection at the top of washer bottles, or can be used wherever you need the tubing to turn a very tight corner without flattening the tubing. Uses 3/16' (4 mm) washer tubing
Has 30% larger, heavy duty, 12 volt motor and pumps a higher volume than standard pumps. Fit with a 30 mm 'P' clip
12 volt. Flange mounted
12 volt. Fits with 30 mm 'P' clip
12 volt. As shown in picture
Used on many Lucas wiper motors, This ferrule locates the outer drive tube with the rack inside it to the motor.
Goes on the bottom end of the tube inside the washer bottle. Fitted with a filter and a non-return valve. Fits 3/16'' (4mm) tubing
Use in 3/16' (4 mm) washer tubing to keep the system primed for immediate use
For joining two ends of 3/16 in (4mm) washer tubing, incorporating a non-return valve. Made from black plastic, there is an arrow moulded in which indicates the direction of flow (you may have to look hard to see it)