2CV Van
You may remember from an earlier post that lurking around here there is a small green 2CV van – a wrinkly bonnet type equipped with a 425cc twin cylinder air-cooled…
Posts by Holden News
2CV Rebuild 10
Prep and Paint At the weekend I started to clean off the rear suspension units using an angle grinder and wire brushes see http://www.holden.co.uk/displayproduct.asp?pCode=092.229 and http://www.holden.co.uk/displayproduct.asp?pCode=095.080 Then using Por15 I’ve…
Tiger tales 7……
These pages have been somewhat free of Tiger tales of late – mostly due to the shell being away with the painters and us leaving them to do their bit…
2CV Rebuild 9
Body off….Simon and Adam from work helped lift the body off the chassis on Friday evening, this is now outside, where it will remain ’till the end of March when…
2CV Rebuild 8
“Houston we have lift off!” Well I thought this was going to be awkward, and I haven’t dropped the fuel tank out yet, as the previous repairs to the floor…
2CV Rebuild 7
Last night I encountered a “that’s not very good” moment. The last 2 bits to strip from inside the car that go through the bulkhead were the clutch pedal assembly…
2CV Rebuild 6
A little less active last weekend, but have started to remove all the fittings that go through the bulkhead prior to lifting the body clear of the chassis.. I’ve got…
VSCC Exmoor Trial
This weekend, a contingent from HVC headed down the M5 to the West Country to take part in the VSCC Exmoor Trial, For those who are not ‘au fait’ with…
2CV Rebuild 5
Last night’s activity was to take the wiring out of the car. It’s relatively easy to remove the wires, however putting them all back again will be quite a…
Engines out….
Never one to be outdone, Jeremy has instigated rebuild projects of his own. His early Vauxhall, having been rebuilt approximately 20 years ago, is having the engine looked at to…
